TLDR: Yes, you can put an ASUS Strix 2080 (and likely any other ASUS Strix card) in the Fractal Design Node 202. Check out the gallery below.
I had to RMA my ASUS Strix 1080 Ti last month; when packing it for shipment I realized it would probably fit inside my Node 202 if I removed the fans and shroud. Thus I decided to upgrade my main PC to an ASUS Strix 2080 Ti and use the replacement card in the Node 202, which ended up being an ASUS Strix 2080. This card is 2.7 slots and larger than the Strix 1080 Ti but I was still able to make it fit inside the Node 202 after removing the fan and shroud. However, there are a few things you should know if you want to try this:
- The bracket and tabs on the heatsink for the fans and shroud protrude far enough to prevent fans from spinning if you set them up to exhaust from the 202. So you have to set the fans as intakes unless you want to rip off the tabs/bracket and void your warranty.
- One of the 120mm fans must be offset from the other because of the tabs on the heatsink. See Pic #3 below.
- One of the screws that secures the GPU bracket to the Node 202 must be removed because it will hit the corner of the Strix PCB. See Pic #4 below.
- You’ll want the Node 202 in vertical position and use pressure optimized fans to get as much air in as possible.
- By relying on 2x120mm fans to cool the Strix 2080, you need a way to control them. The Strix 2080 has external fan headers but the software to control them is buggy and requires a workaround.
I am using ASUS GPU TWEAK II to set a custom fan curve on the external fan headers; the very first time the program runs, an executable named ASUSGPUFanServiceEX.exe launches and then closes immediately. This exe is responsible for applying custom fan curves so without it your custom fan curve is not applied. Launching this exe again fixes that problem but also leaves you with a blank command prompt window. To fix this I use Windows Task Scheduler to launch a Visual Basic script at every startup that will run and hide the program:
1 2 3 4 |
Dim WShell Set WShell = CreateObject("WScript.Shell") WShell.Run """C:\Program Files (x86)\ASUS\GPU TweakII\ASUSGPUFanServiceEX.exe""", 0 Set WShell = Nothing |
I haven’t done any rigorous testing but GPU temperatures seem to be decent. I’ve been playing Witcher 3 again at 1800p (custom resolution 3200×1800 with GPU scaling to 4K) on the Ultra Graphics and High Post Processing presets; temperatures generally range from 60C to 70C. My fan curve is set to run at 100% at 70C.
While it can be done, I would not recommend buying an ASUS Strix card if you already have a Node 202. It’s much easier and simpler to just use a 2 slot card. If you want to use the ASUS Strix for a new ITX build, buy a case that can actually hold it like the Cerberus or a Define Nano S with an SFX power supply.